A-138 Rubber Spreading Adhesive
PRODUCT DESCRIPTION
It is a two-component, polyurethane-based, rubber and EPDM adhesive that is applied with the self-leveling method.
SCOPE OF APPLICATION
In industrial rubber coatings
It can be spread on concrete, asphalt, metal, rubber roller, rubber, wood, felt, cork and different products and adhered to the floor with a non-rigid system of rubber, sbr, epdm, sand, mosaic, small pebbles, many decorative products on the floor before the product dries. used.
In insulating coatings.
FEATURES
It has a self leveling feature.
It has high bonding strength.
It is resistant to water, humidity and heat.
The product does not decompose, does not open or leave.
No press required.
Can be applied at + 5 / + 40°C.
Pot life (Practice time):
20-30 Minutes
Drying time:
4-6 hours
APPLICATION
The surface to be applied should be swept, clean, free from oil and dirt, especially dry, repaired surface. 2 mixtures should be mixed homogeneously with the help of a drill or mixer in the specified amount, not exceeding 1 minute, without dragging air, then poured into another empty package and mixed again. It will not dry out in certain areas. In case of excessive mixing, the product gets thicker in its package by heating, it comes out of the application density and freezes). Maximum 15-20 minutes. EPDM or similar products are sprinkled on the surface without impermeability and left to dry in such a way that there is no open area. Under normal conditions, curing is 30-45 minutes, drying time is 1.5-2 hours. In hot environments, the time may be shortened, and in cold environments, this period may be longer. After 24 hours, the excess of the sprinkled product is swept and opened to traffic. If it is desired to increase the resistance of the product against impacts, it is protected with polyurethane varnish.
APPLICATION TOOLS: It is applied with a toothed trowel or spatula.
The product, which has A and B components mixed, should be used immediately.
