A-121 Polyurethane Carpet and Tile Rubber Adhesive
PRODUCT DESCRIPTION
It is a polyurethane-based, solvent-free, two-component, thixotropic multi-purpose adhesive.
SCOPE OF APPLICATION
In artificial turf application and bonding,
Industrial rubber coatings (poliçim, regupol etc.), insulation coatings,
Bonding of natural stone, ceramic, granite, marble and decorative bricks, bonding of PVC floor tile coverings,
It is used in bonding chipboard, chipboard, styrofoam, polystyrene sheet, acoustic sound insulation, Bonding of concrete, glass, asphalt, metal, wood, plastic, felt, cork and different products, Indoor and outdoor, in ship-boat construction.
FEATURES
It is solvent free adhesive.
It has high bonding strength.
It is resistant to water, humidity and heat.
Adhesion of non-absorbent surfaces (for example: steel, glass on metal surface, marble,
ceramic, plastic bonding) gives good results.
The product does not decompose, does not open or leave.
No press required.
Can be applied at + 5 / + 40°C.
Pot life (Practice time):
20-30 minutes
Drying time:
4-6 hours
APPLICATION
The floor on which the adhesive will be applied should be clean, dry, free of oil and substances that prevent adhesion to the floor with the help of solvent. The 'Basic Material' is mixed in the PU adhesive first, then the entire hardener is poured into the base material and mixed until a homogeneous mixture is obtained without dragging air. To make sure that the mixture is completely done, transfer all the ingredients to another container and mix again until you get a smooth mixture. Mixing should be done with an electric mixer. The mixture should be used within 20-30 minutes. Under normal conditions, curing is 30 minutes, drying time is 4-6 hours. It is recommended to apply the adhesive on both surfaces on surfaces exposed to a small amount of moisture. The time is shortened in hot and intensely humid weather conditions, and this period may be longer in cold environments. The product does not stick to wet and very damp surfaces.
APPLICATION TOOLS: It is applied with a toothed trowel or spatula.
The product, which has A and B components mixed, should be used immediately.
