E-86 Epoxy Moisture Barrier for Damp Surfaces
PRODUCT DESCRIPTION
It is a 2-component epoxy floor primer used on slightly damp surfaces to cut moisture from the floor, to prevent dusting, and to increase the adhesion of the surface.
SCOPE OF APPLICATION
It is applied as a moisture barrier primer under the coating to be made indoors and outdoors.
It can be used as an economical coating by applying 2-3 layers in factories and parking lots.
Gypsum gypsum is used as a transparent coating so that the products do not deteriorate from moisture.
Marble, tile, mosaic, ceramic etc. It is used to prevent dusting on surfaces.
FEATURES
Epoxy, polyurea, polyurethane etc. It provides very good performance as a floor primer for floor coatings and adhesives.
It prevents dust on the floor.
After the product dries, it prevents moisture from the floor
It eliminates the adhesion problems (reaction deterioration) of the adhesive caused by the ground. It is UV resistant.
It has high adhesion and adhesion strength. Its insulation is suitable for floors with underfloor heating.
It is resistant to water, humidity and heat after application. Frost resistant
+10 / +30 Oc can be applied.
Solvent-free, does not cause bad smell.
Extremely resistant to dilute acids, alkalis, and cleaning agents.
Usage time (23°C, Pot Life):
60 minutes
Full drying and mechanical strength time:
5 days
Drying time (at 25 °C):
≤24 hours
APPLICATION
The surface on which the primer will be applied should be clean, free from oil and dirt, especially dry, repaired surface. All of the hardener is poured into the main material and mixed until a homogeneous mixture is obtained without dragging air. In order to make sure that the mixture is fully made, put the ingredients in another container and mix again until you get a smooth mixture. Mixing should be done with an electric mixer. The material is applied to the floor with the help of a brush or roller. Under normal conditions, curing is 2-3 hours and drying time is 24 hours. In hot environments, the time is shorter, and in cold environments, this time may be longer. In order to avoid the problem of unreacted resin that may remain on the surface of the container, pour it into a separate clean container after making the mixture, mix it again and use it. In applications below 5°C, carbonization problem may occur on the surface.
APPLICATION TOOLS: Roller or brush
