A-110 Polyurethane Adhesive
PRODUCT DESCRIPTION
It is a polyurethane-based, solvent-free, two-component, thixotropic multi-purpose adhesive.
SCOPE OF APPLICATION
Wooden parquet, laminated bonding
Laminate MDF, chipboard lam bonding.)
Bonding of natural stone, ceramic, granite, marble and decorative bricks, bonding of PVC floor tile coverings,
It is used in bonding chipboard, chipboard, styrofoam, polystyrene sheet, acoustic sound insulation, Bonding of concrete, glass, asphalt, metal, wood, plastic, felt, cork and different products, Indoor and outdoor, in ship-boat construction.
FEATURES
It is solvent free adhesive.
It has high bonding strength.
It is resistant to water, humidity and heat.
Adhesion of non-absorbent surfaces (for example: steel, glass on metal surface, marble,
ceramic, plastic bonding) gives good results.
The product does not decompose, does not open or leave.
No press required.
Can be applied at + 5 / + 40°C.
Pot life (Practice time):
20-30 Minutes
Drying time:
4-6 hours
APPLICATION
The floor on which the adhesive will be applied should be clean, dry, free of oil and substances that prevent adhesion to the floor with the help of solvent. The PU adhesive is first 'mixed' in itself, then all of the hardener is poured into the main material and mixed until a homogeneous mixture is obtained without dragging air. To make sure that the mixture is done completely, take it into another container with the ingredients at the bottom and around it and mix it again until you get a smooth mixture. Mixing should be done with an electric mixer. The mixture should be used within 20-30 minutes. Under normal conditions, curing is 30 minutes, drying time is 4-6 hours. It is recommended to apply the adhesive on both surfaces on surfaces exposed to a small amount of moisture. The time is shortened in hot and intensely humid weather conditions, and this period may be longer in cold environments. The product does not stick to wet and very damp surfaces.
APPLICATION TOOLS: It is applied with a toothed trowel or spatula.
The product, which has A and B components mixed, should be used immediately.
